AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Dd wrt v24 sp2 problem9/6/2023 ![]() You could use a Wireless Bridge to transparently connect computer(s) in one room to computer(s) in a different room when you could not, or did not want to run an Ethernet cable between the rooms. ![]() Since the computers are on the same subnet, broadcasts will reach all machines, allowing DHCP clients in one segment to get their addresses from a DHCP server in a different segment. The two segments will be in the same subnet and look like two Ethernet switches connected by a cable to all computers on the subnet. ![]() Wireless Bridging is used to connect two LAN segments via a wireless link. It is being kept as there might be info that some find useful, but ***THESE INSTRUCTIONS SHOULD NOT BE USED*** Use the more complete and up to date guide to do the same thing that can be found here: This is an older page on how to set up a client bridge. They can connect to the main Router using WiFi no problem.You are here: DD-WRT wiki mainpage / Linking Routers / Wireless Bridge ![]() However, my Sony PS3 (Wired and WiFi) and Android (WiFi N) devices can not access or see anything as these NON-Windows devices can NOT get a IP address from the WAP: Stuck at 'Obtaining IP address'. I can access the Internet and Local LAN using my Windows 7 64bit over Wireless and LAN port the WAP. I tried these settings:Ī) AP, Mixed, Dynamic (20/40) Channel Width, Auto Channel, OPEN/Disabled Securityī) AP, Mixed, Dynamic (20/40) Channel Width, Auto Channel, WEP Security (64bit)Ĭ) AP, Mixed, Dynamic (20/40) Channel Width, Auto Channel, WPA2 Personal (AES) Security DD-WRT Wireless Access Point ( TP-Link TL-WR841ND v7.1 DD-WRT v24-sp2 (02/11/13) std - build 20675, Regular using the instructions found in the link above: Turn on DHCP forwarder to point to Router's IP 192.168.1.1, WAP IP: 192.168.1.2). Powerline (Belkin F5D4077) -> Switch ( Trendnet TE100-S50g)ģ. Here is my setup first (connected using Ethernet cable).ġ. ![]() I have done this before without any problems but now with my new devices I have the following problem. I have a question about setting up a DD-WRT Wireless access point. ![]()
0 Comments
Read More
Leave a Reply. |